proxy-attribute
Configures RADIUS server‘s attribute behavior when proxying
through a wireless controller or a RF Domain manager
Supported on the following devices:
- Access Points:
AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP7602, AP7612, AP7622, AP7632,
AP7662, AP8163, AP8533.
- Service Platforms:
NX5500, NX7500, NX9500, NX9600
- Virtual Platforms: CX9000, VX9000
Syntax
proxy-attribute [nas-identifier|nas-ip-address]
proxy-attribute [nas-identifier [originator|proxier]|nas-ip-address [none|proxier]]
Parameters
proxy-attribute [nas-identifier [originator|proxier]|nas-ip-address [none|proxier]]
|
nas-identifier [originator|proxier]
|
Uses NAS identifier
- originator – Configures the NAS identifier as the
originator of the RADIUS request. The originator could be an AP, or a
wireless controller with radio. This is the default setting.
- proxier – Configures the proxying device as the
NAS identifier. The device could be a controller or a RF Domain
manager.
|
| nas-ip-address [none|proxier] |
Uses NAS IP address
- none – NAS IP address attribute is not
filled
- proxier – NAS IP address is filled by the
proxying device. The device could be a controller or a RF Domain
manager. This is the default setting.
|
Examples
nx9500-6C8809(config-aaa-policy-test)#proxy-attribute nas-ip-address proxier
nx9500-6C8809(config-aaa-policy-test)#proxy-attribute nas-identifier originator
Related Commands
| no
|
Resets RADIUS server‘s proxying
attributes |
